MY22H03 - 22_1.0_01.10.2021
73
Operation
6.3
System messages
6.3.1
On-board computer warnings
Figure 68: Example: Warning W0110
Code
Cause
Limitation
Remedy
W011
The bike's speed cannot be
detected.
The maximum speed before
pedal assistance is provided
may be lower than normal.
1
Check that the speed sensor is fitted correctly.
2
If the problem persists, contact your specialist dealer.
W013
The torque sensor may not
have been initialised
completely successfully.
Pedal assistance may be less
than normal.
1
Remove foot from the pedal.
2
Press On-Off button (battery).
The system switches on again.
3
If the problem persists, contact your specialist dealer.
W032
A mechanical rear derailleur
may have been fitted instead
of an electronic one.
The pedal assistance provided
in the WALK level of assistance
is possibly less than normal.
1
Re-fit the front derailleur for which the system is
designed.
2
If the problem persists, contact your specialist dealer.
W105
Unexpected power cut-out
detected.
…
1
Switch drive system off and on again.
2
If the error continues to be displayed, contact your
specialist dealer.
3
Check whether the battery mount is loose.
4
Check whether the mains cable is disconnected.
W200
(W020)
If the temperature exceeds
the guaranteed operating
range, the battery will
switch off.
Drive system won’t start.
If the temperature range within which discharging is
possible has been exceeded, allow the battery to cool
down in a cool place with no direct sunlight until the
battery's internal temperature has dropped
sufficiently.
If the temperature is lower than the temperature at
which discharge is possible, place the battery in a
warm indoor room until the battery's internal
temperature has risen sufficiently.
W302
(W032)
A gear shift unit that differs
from the system configuration
was fitted.
No shifting is possible.
Contact your specialist dealer.
Table 31: List of SC-E5003 warnings
