MY22H03 - 22_1.0_01.10.2021
132
Operation
MTB control panel
Figure 146: MTB control panel
1
Switch Y
2
Switch X
Control panel on the left side of the
handlebars
If there is no switch A on the control panel, the
button on the on-board computer will assume
these functions.
6.21.0.1 Using the riding light
The drive system must be switched on.
Press the light button.
The light is switched on. The riding light symbol
is shown on the display screen.
Press the light button.
The light is switched off.
6.21.1 Using the push assist system
The push assist helps the rider to push the
bicycle. The speed can be a maximum of 6 km/h
in this case. The tractive power of the push assist
and its speed can be influenced by the selection
of gear. We recommend using first gear for cycling
uphill to protect the drive.
6.21.1.1 Select WALK level of assistance
Press
switch Y (left)
about 2 seconds.
The level of assistance WALK is displayed.
If a warning is sounded during switchover, it is
impossible to switch to the WALK level of
assistance. This may be due to the current
speed not being 0 km/h, pressure being
applied to the pedals or similar.
Release
switch Y (left)
.
6.21.1.2 Switching on the push assist
Press
switch Y (left)
to switch on push assist.
6.21.1.3 Switching off the push assist
Release
switch Y (left)
to switch off push
assist.
6.21.1.4 Exit WALK level of assistance
Push
switch X (left)
to change from the WALK
level of assistance to the level of assistance
last used.
If
switch Y (left)
is not pushed for longer than
one minute, the level of assistance is reset to the
level of assistance used previously.
Switch
Function
WHEN RIDING
X
Increase level of assistance
Y
Reduce level of assistance
A
Switch journey data displayed
WHEN ADJUSTING
X
Move cursor or change the settings
Y
Move cursor or change the settings
A
Change display or confirm setting change
1
2
Injury caused by pedals
The pedals turn when using the push assist due
to the system design.
You must steer the bicycle securely with both
hands when using push assist.
Allow for enough freedom of movement for the
pedals.
CAUTION
!
