30
9. Display Selection
Read Chapter 7 Before Use of
These Pages
9. Display Selection
9.1 Bar graph display
The relative amount of the load on the pan is displayed in the bar graph. This feature helps to prevent
errors due to OL (overload) status. This is called Full Scale mode. This display can not be used with
the Checkweighing or Target mode.
Select the menu item
to set up Full Scale mode.
A bar displayed in the lower areas of the scale
indicates that the load on the pan is small. (1)
A bar displayed up to the upper areas of the scale
indicates that the load on the pan is close to the
weighing capacity. (2)
To display no bar graph, select menu item
.
9.2 Changing the Minimum Display Digit (10d:1d)
It is possible to decrease the resolution of the minimum balance display by one decimal place if neces-
sary.
1
Press and hold the
[UNIT]
key for approxi-
mately three seconds. “- 10d -” is displayed and
the display is decreased by one decimal place.
2
Press and hold the
[UNIT]
key for approxi-
mately three seconds. “- 1d -” is displayed and the
display returns to the original number of decimal
places.
11
(Examples)
(1)
(2)
21
Note
The location of the decimal point in the display does not shift. In the “10d”
display, the last digit is empty.
