21
6. WindowsDirect Function
6.2.2
Connecting the RS-232C Cable
1
Check that the balance is in “oFF” or “STAND-
BY” status.
2
Remove power from the balance and turn off
the computer.
3
Connect the RS-232C cable to the RS-232C
connector on the back of the balance.
4
Connect the RS-232C cable to the computer.
Notes
• When data is outputted to the computer by WindowsDirect function, the
effect is the same as “typing the numerical value displayed on the bal-
ance and pressing Enter key on the computer’s keyboard”. If you wish
the effect of “
pressing
→
key
” instead of “
pressing Enter key
” on the
computer’s keyboard”, select “SEtwin -” in the above step
1
, instead of
“SEtwin |”. The “SEtwin -” setting menu display appears when the
[MENU]
key is pressed one more time from “SEtwin |”.
• The communication parameters selected by “SEtwin -” or “SEtwin |” set-
tings here are listed in the table in
.
• After WindowsDirect setting has been made using the “SEtwin -” or
“SEtwin |” setting, individual communication parameters can be changed
using the Communications Settings menu (
). In this case, the
(stability mark) may still appear if you go to the “SEtwin -” or “SEtwin |”
display but WindowsDirect may not operate. To restore WindowsDirect
optimal settings then, first remove the stability mark by pressing the
[O/T]
key at the “SEtwin -” or “SEtwin |” display. This restores the default Com-
munications settings. Then, reset “SEtwin -” or “SEtwin |” following the
procedure described in
(When not set)
(When set)
RS-232C connector
