The
STEREO
Knob
The
STEREO
knob affects LFO phase in the right channel. As a
secondary function, it is accessed by holding down the ALT/TAP
footswitch.
Set the knob fully CCW to have the phases perfectly in sync. In the
fully CW position, the phase is offset by 180 degrees. Keep in mind
that phase offset values can be different from 0 in various elements
of the signal chain; this means that the STEREO knob will either
“expand” the stereo stage or move the elements to different positions in the stereo field, depending on the patch.
Bypass and Indication
The dry signal path is fully analog throughout the whole pedal. No distortion is applied to the dry signal. Due to the
Prism II’s active bypass, there is no audible clicking, and three independent global modes are available (selectable by
the
BEAT
switch while holding down the
ON
footswitch):
●
UP:
“No tails” mode. The effect is only heard when the pedal is engaged in the signal chain and turns off
immediately when the ON footswitch is pressed.
●
CENTER:
“Tails” mode. After you have switched the pedal off via the ON footswitch, it keeps playing reverb
reflections but the incoming signal is no longer processed.
●
DOWN:
“Kill Dry with tails” mode. The dry signal is completely removed from the output. Just like the previous
mode, this one only engages the input when you press the ON footswitch. The reverb tails are played till the end,
so that the sound doesn’t get cut off abruptly. This mode is highly recommended when using the Prism II as an
insert effect (where only the wet signal is needed) or in external wet/dry mixing setups.
The bypass mode is displayed upon selection and upon power-up. The LED above the ON footswitch flashes five
times in one of the following colors:
●
Red:
“No tails” mode.
●
Blue:
“Tails” mode.
●
White:
“Kill Dry with tails” mode.
ON/HOLD
LED
The ON/HOLD LED has five functions:
1. On/off indication. If the pedal is bypassed (disengaged from the signal chain), the LED doesn’t light up.
2. Active bank indication. Upon power-up, the LED displays the selected bank: Blue, Red, Magenta or Cyan.
3. Detune Mode status indication. When the ON/HOLD footswitch is held down, the LED flashes in various colors.
4. “Favorite” status indication. When the Favorite preset is recalled, the ON/HOLD LED glows green. If the pedal is
bypassed, the LED flashes briefly to indicate that the Favorite preset will be active when the pedal is turned on. If
the Favorite preset has been changed but not saved, the LED flashes briefly.
5. Bypass mode indication upon selection or power-up.
TAP/ALT
LED
The TAP/ALT LED has four functions:
1. Tempo indication. The TAP LED flashes in sync with the current tempo, taking the BEAT switch and TAP SCALE
knob values into account.
2. USB connection indication. The TAP/ALT LED flashes blue/”current mode” when the pedal is connected via USB.
3. TP mode indication. The TAP/ALT LED lights up in magenta in this mode. It also indicates that secondary
functions (printed in blue) are being accessed.
4. Global mode indication:
●
White:
TP (tap tempo mode).
●
Red:
RS (LFO reset mode).
●
Yellow:
EX (expression pedal simulation mode).
Содержание Prism II
Страница 1: ...Prism II Stereo Filter Pad User Guide ...
