Shift Line Astronaut V, Руководство пользователя

Страница: 14 / 20

MIDI Setup
While in Setup Mode , set the BANK switch to the CENTER position.
Parameter settings use dual-function indication: the ON LED displays the CHARACTER and DECAY knob parameters. If
the parameters are disengaged, the LED doesn’t flash.
The MIDI Setup page provides access to the following settings:
●
MIDI channel is selected via the PROGRAM knob. Set the PROGRAM knob to the desired position. The PROGRAM
knob’s 11 positions correspond to MIDI channels 1-11. MIDI channel 1 is selected by default.
If you wish to select MIDI channel 12-16, you need to do it over USB .
●
MIDI Clock Setup is done via the CHARACTER knob:
○
7:00 (fully CCW): Internal clock is used. MIDI Clock isn’t accepted. The ON LED doesn’t flash cyan.
○
5:00 (fully CW): External clock is used. MIDI Clock is accepted (default setting). The ON LED flashes cyan.
● MIDI Program Change (PC) Setup : The pedal accepts 33 MIDI PC messages (0-32).
You can enable or disable MIDI PC messages via the DECAY knob:
○ 7:00 (fully CCW): PC messages aren’t accepted. The ON LED doesn’t flash yellow.
○ 5:00 (fully CCW): PC messages are accepted (default setting). The ON LED flashes yellow.
Expression Pedal Setup
Expression pedals with resistances of 10 or 25kOhm with a TS (mono) connection work best with the pedal. You can
also use 10-25kOhm expression pedals with TRS (stereo) connections, but the response curve will be less linear in
that case. You can currently control the DECAY knob with an expression pedal. More parameters will be made
available for expression pedal control in further firmware updates.
While in Setup Mode , set the BANK switch to the DOWN position.
The Expression Pedal Setup page provides access to the following settings:
●
Expression pedal type is set via the CHARACTER knob:
○ 7:00 (fully CCW): TS (mono). The ON LED flashes white.
○ 5:00 (fully CW): TRS (stereo). The ON LED flashes red.
●
Expression pedal calibration is done as follows:
○
Plug the expression pedal into the CTRL input jack.
○
Set the expression pedal to the max position.
○
Set the BEAT switch to the UP position.
○
Press the ALT footswitch.
○
The ALT LED will flash green. This means the max value has been set.
○
Set the expression pedal to the min position.
○ Set the BEAT switch to the DOWN position.
○
Press the ALT footswitch.
○
The ALT LED will flash green/blue. This means the expression pedal has been successfully calibrated.