Shenzhen Hongdian Technologies H792x, Руководство пользователя

Страница: 83 / 129

H92x 3G/4G Router 7 FAQ
Version (2014-05-28) 7 -49
Figure 5-51
RIP route configuration interface
Step 6
Configure RIP route parameter instruction, as Table 5-27.
Table 5-26 RIP parameter instruction
Parameter Details Operation
Basic Setting
Add Type Add the type of RIP route Click the button to select Add Type

When it is “Network”, need to
configure destination network address.

When it is “Neighbor”, need to
configure neighbor’s IP address
Network(directly
connect to the
router) Add the destination
network of RIP route Add the destination network of RIP
route
Format: A.B.C.D/Mask
Neighbor(directly
connect to the
router) Add the neighbor’s IP
address of RIP route Add the neighbor’s IP address of RIP
route
Format: A.B.C.D
Step 7 Single click “save” icon to RIP route setting.
RIP is an interior gateway protocol. In the national networks ( such as the current Internet ) , has a lot for
the entire network routing protocols. Only adjacent routers exchange information. If the communication
between the two routers do not go through another router , the two routers are adjacent. RIP agreement,
without the exchange of information between non-adjacent routers.
Routers exchanging information is all the information currently known to the router . That is its own
routing table. At a fixed time to exchange routing information ( such as every 30 seconds ) , then the
router receives the routing information to update the routing table.
RIP protocol "distance" also known as " hops " (hop count), because each through a router hop count is
incremented . RIP is considered a good route it through a small number of routers , namely, " a short
distance ." RIP allows a path can contain up to 15 routers. Therefore, the "distance" equal to 16 hop
which is equivalent unreachable. RIP visible only for small Internet.
---END