05_62807_62810_A2
Page 12
10. cover instAllAtion - continued
After pulling the cover over the frame, make sure to center cover on frame. There should be an equal
amount of overhang at all four corners.
E.
Insert the “S”- Hook on ratchet (# 10040) into hole on the leg bend. Insert the webbing into the spindle of the
ratchet and pull tight. Wind the ratchet so that the webbing overlaps itself.
F.
Slide Cover Rails (# 801345) through fabric pockets in cover and attach with clamps (# 801342 & # 801343)
at about 8 inches up from the ground to each leg. Repeat this on other side. Push down on cover rails to
tighten cover before tightening bolts (# 00648) completely.
NOTE: Place Cover Rails and Clamps UNDER the Anchoring Cables.
G.
Check and tighten Ratchets and Cover Rails monthly to ensure the cover is tight.
NOTE: The ShelterLogic
®
logo should
be oriented as shown below.
CORRECT
INCORRECT
801343
801343
00648
00648
00828
0690A
00690
10040
801342
801345
00690
0690A
e
F
