Shaver Grand Slam, Руководство оператора и каталог запасных частей

Страница: 12 / 56

12
Mounting Instructions
Rear-Mounted (3-Point Hitch)
1. Place three-point hitch weldment upside
down on the floor. Install storage leg
brackets with storage legs installed, over
the cross tube, as shown. Tighten two leg
bracket bolts to secure the brackets to the
cross tube.
2. Set storage leg height
‘X’
measured from
three-point hitch weldment mounting angles
to the storage leg base plate, as shown.
Tighten the storage leg lock bolts.
a. For UPPER Base Plate mounting position set
‘X’
at
36”
(91.44 cm).
b. For MIDDLE Base Plate mounting position
set
‘X’
at
45”
(114.3 cm).
c. There is no useable dimension
‘X’
for
storage legs when diver is in the LOWER
Base Plate mounting position
3. Turn over three-point hitch weldment and
set it on storage leg base plates.
Self-Contained Mounting Package
(Skid-Loader)
1. Remove the plugs from the hydraulic
reservoir, pump, and motor.
2. Place Universal Mounting Bracket (item 1)
on the floor. I n s t a ll t h e Reservoir Bracket
(item 3) on the outside of the mounting
angles on the Universal Mounting Bracket
with two (2) each 1/2" bolt, lock washer and
nut (items 9, 10, & 11). Attach the
Pump/Motor/Reservoir (item 2) by lining up
the slots in the Pump/Motor/Reservoir with
slots in the Universal Mounting Bracket and
the Reservoir Bracket, then secure four (4)
each 3/8
”
bolt & lock nut and eight (8) flat
washer (see below).
OH-200 - Self-Contained Mounting Package Assembly.
Item Qty.
Part No. DESCRIPTION
1 1 MBS-77-20 Bracket Assy., Universal Mtg.
2 1 OH-101-1 Pump/Motor Kit, Complete
3 1 OH-101-2B Frame Weldment, Reservoir Bracket
4 1 SM-0252-R Hose Assy., Hyd. 3/4 ”
x 48
”
3/4
”
MNPT
5 1 300340 Bushing, Reducer 1 ” NPT x 3/4" NPT
6 3 SM-1022-P Hose Assy., Hyd. 1/2" x 54 ”
1/2" MNPT
7 1 CT-832-MC Coupler, 1/2 ” Male Flat Face
8 1 CT-832-FC
Coupler, 1/2
”
Female Flat Face
9 2 300326 Screw, Cap 1/2 -13 x 3 Hew Head Gr5 Zn
10 2 300101 Washer, Lock 1/2 Zn
11 2 300102 Nut, Hex 1/2-13 Zn
12 4 300189
Bolt, Tap 3/8-16 x 1
”
Gr5 Zn
13 8 300178 Washer, Flat 3/8 Std. Zn
14 4 300181 Nut, Lock 3/8-16 Zn
‘X’