Shaver Grand Slam, Руководство оператора и каталог запасных частей

Страница: 11 / 56

11
Assembly Procedure
Unpacking
Due to the size and weight of the
Post Driver, two people are required
for the assembly procedures.
The Post Driver is shipped in several sections:
the Driving Ram Assembly, Base P la t e
Assembly, Hose and Valve Carton, Safety Arm
Carton, and the Tilt Cylinder Carton.
Before starting the unpacking
procedure,
make sure the
overhead lifting device or
material handling device
(forklift) has adequate lifting
capacity. Follow all safety recommendations
when unpacking the Post Driver. Some
components are heavy and can cause
serious injury or death if not adequately
supported during removal and assembly.
NOTE: For ease of assembly, unload the Post
Driver components in the area where they will
be assembled. Choose a large, hard surface
area that can safely support the weight of the
assembled Post Driver and is accessible by
the machine it will be mounted on.
Assembly - General
NOTE : Refer to the Service Parts section of this
manual for an illustration and description of all the
parts.
The Main Carriage Channel has provisions for
mounting the Base Plate in three positions.
• The
Middle Position (most common) -
three-point hitch.
• The
Upper Position
• The
Lower Position - for driving 10 ft. (3.0
m) tall posts only - three-point hitch
(smaller tractors).
Driver and Base Plate on 3-point mount shown in
Middle Position.
The Post Driver assembly procedure consists of
the following subsections:
1. Main Carriage Channel
2. Storage Legs
3. Base Plate
4. Hydraulic Valve
5. Safety Stop Adjustment
6. Rubber Debris Guard
7. Safety Arm
8. Manual Storage Tube
UPPER
LOWER
MIDDLE
WARNING