shars 101-1008, Руководство по эксплуатации

Страница: 8 / 46

Version 1.0.4 dated 2014-09-19 Page 8 Original operating instructions
1.4 Possible dangers caused by the grinding machine for burins
The grinding machine for burins is state-of-the-art.
Nevertheless, there is a residual risk as the grinding machine for burins operates with

at high speeds,

rotating parts,

with an abrasive wheel (flying sparks)

with electrical voltages and currents.
We have used construction resources and safety techniques to minimize the health risk for the
staff resulting from these hazards.
If the grinding machine for burins is used and maintained by the staff who are not duly qualified,
there may be a risk resulting from incorrect or unsuitable maintenance of the grinding machine
for burins.
INFORMATION
All staff involved in assembly, commissioning, operation and maintenance, must

be duly qualified,

strictly follow these operating instructions.
In the event of intended use

there may be a risk to the persons,

there may be a risk to the grinding machine for burins and other material values,

the correct function of the grinding machine for burins may be affected.
Always disconnect the mains plug from the socket before performing any cleaning or mainte-
nance works.
1.5 Qualification of personnel
1.5.1 Target group
This manual is addressed to

the operating companies,

the operators,

the staff for maintenance works.
Therefore, the warning notes refer to both, operation and maintenance staff of the grinding
machine for burins.
Determine clearly and explicitly who will be responsible for the different activities on the
machine (operation, maintenance and repair).
Unclear responsibilities constitute a safety risk!
The qualifications of the staff for the different tasks are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. Any tasks which need to be performed beyond the opera-
tion in the standard mode must only be performed by the operator if it is indicated in these
instructions and if the operating company expressively commissioned the operator.
Electrical specialist
Due to his professional training, knowledge and experience as well as his knowledge of respec-
tive standards and regulations the electrical specialist is able to perform works on the electrical
system and to recognise and avoid any possible dangers himself.