E-16
EN
Enhancing your system
The connection lead is not included. Purchase a commer-
cially available lead as shown below.
MICRO COMPONENT SYSTEM XL-LS703B
Audio cable (not supplied)
Portable audio player, etc.
■
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection lead to connect the portable audio
player, etc. to the AUDIO IN socket.
2
Press the ON/STANDBY button to turn the power on.
3
Press the AUDIO IN button (remote control) or FUNC-
TION button repeatedly (main unit) to select AUDIO
IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, adjust the volume of the
connected device.
Note:
To prevent noise interference, place the unit away from
the television.
■
Headphones
●
Do not set the volume on to maximum at switch on.
Excessive sound pressure from earphones and head
-
phones can cause hearing loss.
●
Before plugging in or unplugging the headphone, re-
duce the volume.
●
Be sure your headphone has a 3.5 mm diameter plug
and impedance between 16 and 50 ohms. The recom-
mended impedance is 32 ohms.
●
Plugging in the headphone disconnects the speakers au-
tomatically.
Troubleshooting chart
If something is wrong with this product, check the following be-
fore calling your authorised SHARP dealer or service centre.
■
General
Symptom
Possible cause
●
The clock is not set to
the correct time.
●
A power failure occurred.
Reset the clock. (Refer
page 6)
●
When a button is
pressed, the unit does
not respond.
●
Set the unit to the power
standby mode and then
turn it back on.
●
If the unit still malfunc-
tions, reset it. (Refer page
17)
●
No sound is heard.
●
The volume level set to
“Min”.
●
The headphones are con-
nected.
●
The speaker wires are not
connected.
■
Remote control
Symptom
Possible cause
●
The remote control
does not operate.
●
The AC power lead of the
unit is not plugged in.
●
The battery polarity is
wrong.
●
The batteries are dead.
●
The distance or angle is
incorrect.
●
The remote control sensor
receives strong light.
■
Tuner
Symptom
Possible cause
●
The radio makes
unusual noises con-
tinuously.
●
The unit placed near a TV
or computer.
●
The FM aerial is not
placed properly. Move the
aerial away from the AC
power lead if it is located
nearby.
■
Bluetooth
Symptom
Possible cause
●
No sound is heard.
●
The unit is too far from the
Bluetooth
audio source
device.
●
The unit is not paired
with the
Bluetooth
audio
source device.
●
Bluetooth
sound
is interrupted or
distorted.
●
The unit is too near to
a device that generates
electromagnetic radiation.
●
There is an obstacle
between the unit and the
Bluetooth
audio source
device.
■
NFC
Symptom
Possible cause
●
NFC-enabled device
cannot connect to
Bluetooth
when
tapping on N-Mark.
●
The unit is in Eco mode.
●
●
NFC●mode●is●disabled●on●
your●device.
●
●
Your●device●is●in●sleep●
mode.
