Sharp UX-B800A, Руководство по обслуживанию, Страница: 17 / 140

UX-B800A
2 – 3
e) Pressing [8] key moves the cursor to the data number 1 of the
10th former soft switch.
f) Pressing [2] key moves the cursor to the data number 1 of the
10th next soft switch.
2.1.3 Data setting
Press the [1] key, and the data to the position of the cursor will be
changed to 1.
Press the [0] key, and the data to the position of the cursor will be
changed to 0.
2.1.4 Outputting method of soft switch list
In the soft switch mode, press [COPY/HELP] key, and the soft switch
list will be printed.
2.1.5 Storage of data
In the following cases, the data if the soft switches set will be stored.
• It is shifted to set the next soft switch by pressing [START/MEM-
ORY] key.
• If is shifted to set the former soft switch with the [<] or [UP] or [4]
key.
• It is shifted to set the next soft switch with the [>] or [DOWN] or [6]
key.
• If is shifted to set the 10th former soft switch with the [8] key.
• It is shifted to set the 10th next soft switch with the [2] key.
2.2. ROM & RAM check
To check the sum value of Firmware or RAM.
2.2.1 Display
2.2.2 Result printing
After checking, the results print starts.
2.3. AGING MODE
A total of 10 sheets of check patterns are printed at 1-hour intervals.
This mode is exited when executed to the end (after 9 hours) or by
pressing the [STOP] key.
2.4. PANEL CHECK MODE
This is used to check whether each key is normally operated or not.
After the test, the test result will be printed.
2.4.1 Flow
Press any key except [STOP] key. At this time, the name of each key
will be displayed every push of the key.
a) When all keys can be inputted, the following message will be dis-
played.
Then the screen will be all displayed in black (refer to (2))and the test
result will be printed.
b) If any key skipped, the following message will be displayed.
A key name that is not pressed yet is displayed so that this test can be
continued.
At that time, pressing the [STOP] key will exit this mode. And the result
will be printed.
2.4.2 Black screen
2.5. CHECK PATTERN MODE
Printing the pattern.
No. Device Alarm Buzzer Remarks
1
Main
ROM
(PROGRAM FLASH) 1 time <Short
sound>
2 SDRAM 3 times <Short
sounds>
SW113=00000000
[8] key
SW103=00000000
SW123=00100100
[8] key
SW133=00000000
[2] key
SW143=00000000
SW123=00100100
[2] key
WAITING
Start checking by pressing
[START/MEMORY] key
SDRAM : OK
PRINTING
DIAG MODE
02:ROM & RAM CHECK
Start by pressing the
[START/MEMORY] key
PRINTING
03:AGING MODE
DIAG MODE
03:AGING MODE
Display during the aging
mode interval
To finish this mode, press [STOP] key
04:PANEL KEY TEST 1
[1] key
[2]Key
2 SPEAKER
Go to a) or b).
..... (other key)
[SPEAKER] key
ALL KEY OK !!
KEY ERROR !!
Start by pressing the
[START/MEMORY] key
PRINTING
DIAG MODE
05:CHECK PATTERN