Sharp PG-LW3000, Руководство по эксплуатации

Страница: 61 / 77

59
Useful
Featur
es
Using 3D Viewing Mode
Use the following procedure to project
3D images.
For operation of the 3D LCD shutter
glasses and the 3D-video playback
equipment, see the corresponding
operation manual.
O / Q
buttons
ENTER button
3D MODE button
Projecting 3D images
1
Turn the projector on.
2
Turn the 3D-video playback
equipment on.
• Set the 3D­video playback equipment so
that it outputs one of the signals listed in
the Compatibility Chart in this operation
manual.
3
Switch the Input mode of the
projector to enable input of 3D
video signals.
4
Operate the 3D-video playback
equipment and play back the 3D
content.
5
Turn the 3D LCD shutter glasses
on and place them over your eyes.
6
Press 3D MODE on the remote
control to display the 3D MODE
menu.
Info
• If “An invalid button has been pressed.”
is displayed, a 3D­compatible signal is
not being input. Check the output signal
on the playback equipment.
7
Press
Q
to set “DLP
®
Link™” to
“On”.
8
Press
ENTER
to switch the mode
and enable more natural 3D
image viewing.
Warning!
• If the projector, 3D­video playback
equipment, and 3D LCD shutter
glasses are not properly set, you may
experience eye strain in addition to not
being able to view the images in 3D.
9
Press 3D MODE .
• The 3D MODE menu will disappear.
• If the images are not displayed in 3D, repeat
steps 6 to 8.
• You can also use “DLP
®
Link™” and “DLP
®
Link™ Invert” on the menu screen to change
the 3D setting.
Note
Ending 3D projection
1
Press
3D MODE
on the remote
control to display the 3D MODE
menu.
2
Press
O
to set “DLP
®
Link™” to
“Off”.
3
Press 3D MODE .
• The 3D MODE menu will disappear.
Viewing Stereoscopic 3D Images (Continued)