Sharp MX 3070, Руководство по устранению неисправностей

Страница: 37 / 56

37
Fax
Did a communication error occur? ■ If an error occurs that prevents transmission, the transmission is temporarily
canceled and then automatically re-attempted after a brief interval. The factory
default setting : Two attempts at 3-minute intervals.

"Setting mode (administrator)" → [System Settings] → [Image Send Settings]
→ [Fax Settings] → [Send Setting] → [Recall in Case of Communication Error]
To cancel transmission, tap the job status display on the operation panel, tap
the key of the job you want to delete, and tap [Stop/Delete] on the action panel.
A message will appear to confirm the cancelation. Tap the [Cancel] key.
The machine supports error correction mode (ECM) and is configured to
automatically resend any part of a fax that is distorted due to noise on the line.

"Setting mode" → [System Settings] → [Image Send Settings] → [Fax Settings]
→ [Default Settings] → [ECM]
Does a message appear indicating
that the memory is full?
■
Divide the originals into sets and fax each set separately, or use direct
transmission.
If the memory becomes full, the transmission will be canceled.
Does a message appear notifying you
that the original size was not
detected? ■ Place the original again.
If the original size is still not detected correctly, specify the original size manually.
Does the job status screen
(completed jobs) or a transaction
report indicate that the transmission
was not successful?
■
Perform the transmission again.
If the transmission is still not successful after recalling is performed as set in
[Recall in Case of Line Busy] or [Recall in Case of Communication Error], the
transmission failure will be indicated in the job status screen and the transaction
report.
Did you place an original that is
folded? ■ Following the instructions in the display, unfold the original, place it in the
automatic document feeder again, and re-scan it.
If a folded original is placed in the automatic document feeder, an error will occur
and scanning will be canceled when the actual original size is detected during
scanning.
Are the sub-address and passcode
correct? (When using F-code
communication)
■
Check with the operator of the other machine to make sure that the sub-address
and passcode are correct.
THE TRANSMITTED FAX PRINTS OUT BLANK AT
THE RECEIVING SIDE
Check Solution
Is the original placed face up or face
down correctly?
■
Place the original again in the correct orientation, and resend.
When using the document glass, the original must be placed face down. When
using the automatic document feeder, the original must be placed face up. Place
the original correctly and send the fax again.
If the receiving machine is using
thermal paper, was the thermal paper
loaded with the wrong side out? ■ Check with the operator of the other machine.
Check Solution
!
?
!