Sharp MX-2640N, Техническое руководство

Страница: 59 / 71

SHARP
IMAGE SEND COMMUNICATION ERROR
59
Report Code
(Result)
Result Displayed Communication Interruption Content
95
NG95 XXXX *1
When the path is too long in execution of Scan To USB.
96
NG96 XXXX *1
When the normal process is not executed in the secure mail sending.
98
NG98 XXXX *1
The copy inhibit pattern is detected when scanning a document.
99
NG99 XXXX *1
A document which is inhibited to be copied such as a banknote is scanned.
*1
For a job status result in "Display in the column of result, NG XXXX is displayed, is the
code number. For a communication result, Communication error (XXXX) is displayed.
*2 The error code of Scan To USB is specified only in the job log.
* When the communication result is OK, the communication sub code 1 and the communication sub
code 2 are 0000. Errors in ( ) are not used.
COMMUNICATION REPORT SUB CODE 1:
The communication report sub code 1 (upper 2 digits) are always indicated as 00 .
COMMUNICATION REPORT SUB CODE 2:-
Report Code 2 Communication Interruption Content Send / Receive
00 When the conditions after 01 do not apply. Send/Receive
01 Send length over Send
02 EOL time up Receive
03
Carrier detection time up Receive
04 Time up of the communication start command from the machine side Receive
05 Time up in phase C (8 min) Send
06 Memory image decode error Receive
07
Memory image decode error Send
08 Time up between frames in phase C (Report code is 0 or 16.) Send/Receive
09 Not used —
10
Not used —
11 Polarity reversion detection Receive
12 Invalid command reception Receive
13 Time up (1-minute timer/6-second time) Receive
14
PUT error Receive
15 In V.34 mode, time up is generated when shifting from Primary to Control. Receive
16 In V.34 mode, time up is generated when shifting from Control to Primary. Receive
17 Command receive time-up from MFP controller Receive
18
Not used —
19 Not used —
20 Polarity reversion detection Send
21 Invalid command reception Send
22
Fall-back retry number over Send
23 Command retry number resend over Send
24 Time up (T5 timer) Send
25 Time up (T5 timer) in V.34 mode Send
26
In V.34 mode, time up is generated when shifting from Primary to Control. Send
27 In V.34 mode, time up is generated when shifting from Control to Primary. Send
28
When sending the FSK signal, no response of send completion is sent back from
the MODEM chip within a certain time. (V.34, other than V.34)
Send