Sharp LC-15L1US, Руководство по обслуживанию

Страница: 23 / 150

23
LC-15L1U-S
1. Checking normal startup with terminal software
After entering the command described below, turn on the power again. If the same contents as shown on the
next page appear on the screen, you can confirm that "SS unit" has been started up normally.
1. Preparations:
1
PC (with Teraterm communication software installed)
2
Dedicated connector cable
(Checkup procedure)
1
When you are done with the connection as shown above, turn on the power.
2
Several seconds after powering up, the screen will stabilize. Then, hold down Shift key and ~ key simultaneously
for a few seconds to call the prompt.
~
Wireless Center prompt = "$"
TV receiver prompt = "%"
When the sequence ~~~.. appears, press Enter key once to
show a single prompt.
3
E n t e r t h e fo l l o w i n g c o m m a n d , a n d p r e s s E n t e r.
"eepw_0x80_0x03" (_ indicates a space.)
4
Turn the power off and then on again.
5
When you have finished checking all display items on the next
page, repeat the steps starting from
1
. In the step
3
, enter
"0xFF" instead of "0x03" to put the setting back to a default.
PC
(with Teraterm
installed)
Wireless Center or
TV receiver
Caution:
"Factory service terminal" on the
rear face
(Connection diagram)
Dedicated connector cable
(QCNW-1914TAZZ)
Serial port
φ
2.5 Jack
After starting Teraterm, set to "Serial"
port on initial screen.
Example of Teraterm screen (Wireless Center side)
L1 PAL TX Version 2C
MPEG Version 05
Before MPEG CMD
MPEG CMD OK
Before MPEG Standby Cmd
MPEG Standby Cmd OK
Debug Monitor Special Version 1.1
Copyright 2001 SHARP CORPORATION.
All Rights Reserved.
$ ~~~~~~~~
Syntax Error
ERROR
$ eepw 0x80 0x03
OK
$