EC-HX100M_P
4
9
Control switch
Starting
Press”
”
during operation
Press only once.
The hot air will be automatically
controlled to the optimum temperature.
The motor power will switch.
Ending
The Warming lamp will turn OFF.
To use the hot air effectively, wait for the Warming lamp
on the cleaner body to light before starting. It will gradually change
from a flicker to a steady light in approx. 30 seconds.
(The cleaner can be used when the light is flickering slowly.)
Switching the motor power
The motor power state is indicated with the Warming lamp
on the cleaner body.
•
The optical sensor
will detect if the suction opening is removed from the bedding
during cleaning, and the beating rubber blade will stop. If the beating rubber blade
does not stop, the optical sensor may be dirty.
•
If the suction opening is removed from the bedding for more than one minute, the Power lamp
will automatically turn OFF and the Warming lamp will turn OFF. (Auto OFF)
•
The beating rubber blade’s rotation speed will not change even if the power is switched.
•
Use of the cleaner in a room temperature of 10 to 35°C is recommended.
•
Do not touch the beating rubber blade, the optical sensor or the area around
the exhaust vent
during operation or immediately after operation.
[ There is a risk of injury or burns to hands, etc. ]
•
If the motor temperature (air temperature) is at the maximum temperature,
the power cannot be changed.In this case, the Warming lamp
will flicker shortly three times.
•
5
Page
The Filter care lamp indicates the filter cleaning cycle. Service the filter as indicated below.
Filter care lamp (red)
When Filter care lamp (red) turns ON
Lighting state
ON
Fast flicker
State/Action
Empty out the contents of the dust cup.
The dust cup assembly filter is dirty.
Remove the dust cup assembly, turn the filter knob, and empty
out the contents.
Wash the filter with water.
The dust cup assembly filter is clogged with dirt.
Remove the filter and wash it with water.
6,7
Page
7-9
Page
Info
Notice
FLOW OF CLEANING PROCESS
USING THE CLEANER
Assembling the Filters
①
②
③
The parts cannot be mounted onto the cleaner if they are not assembled correctly.
•
Take care not to lose the mesh filter (bottom) when emptying the dust cup or cleaning the filters.
•
The filters cannot be assembled if there is any dirt in the base of the dust cup.
•
The filters cannot be assembled if dirt is wound around the mesh filter.
•
Cautions
Align the protrusions.
Align the protrusions.
Lever is up
Lever is depressed
Click
Click
④
Dust disposal
hook
(yellow)
Yellow mark
Wheel (front L/R)
Wheel (rear)
Wheels
If the wheels are worn, stop use and contact your dealer and Sharp Service Center.
•
Use scissors to cut off any entangled thread scraps or hair, etc.
Pay attention to avoid injury.
•
Make sure there is no dirt or foreign matter in the mesh filter
before mounting.[ There is a risk of abnormal noise. ]
•
EC-HX100M_P.indd 4
15/09/25 16:40
