EC-HX100M_P
10
3
NAMES OF EACH PART
SPECIFICATIONS
5
Page
6,7
Page
7-9
Page
CLEANER BODY
Filter care lamp
Suction opening
Open lever for power brush
(Both sides)
Beating rubber blade
Beating rubber blade
Beating rubber blade cover
Cleaner body (with beating
rubber blade removed)
Slip off the belt
Beating rubber blade cover
Dust disposal hook
(yellow)
Dust cup
Mesh filter
Pleat filter
(inside)
Filter cover
Collects dirt.
Open lever for
power brush
(both sides)
Beating rubber
blade cover
Beating rubber
blade
Wheel (front L/R)
Wheel (rear)
Power cord
Cord band
Power plug
Exhaust vent
Optical sensor
(two locations)
Control switch
Handle
Dust cup
ejector lever
When Filter care lamp (red)
turns ON, refer to
Always hold the cleaner
by the handle when carrying
it around. Holding it by
any other part (dust cup, etc.)
could cause the unit to drop,
and cause injuries, faults or
damage to the floor, etc.
Warming lamp
The lighting state
varies according to
the operation state.
(When the Warming lamp
(orange) turns ON,
refer to
The filter inside does not
require servicing.
(It cannot be removed.)
The power plug shape varies by region.
Do not use the cleaner with
the power cord bundled.
(The cord could get hot
and cause faults.)
Base
4,6,7
Page
ACCESSORIES
Power
220-240V 50-60Hz
Power consumption
720W
Dust collection capacity
0.1L
2.7kg(Including power plug)
304mm(W) x 405mm(D) x 254mm(H)
5m
Weight
Main unit dimensions
Cord length
When the Dust disposal hook (yellow) is
pressed, the dust cup will come off and
the contents can be emptied.
Refer to
when servicing each filter.
The mattress cleaner’s motor has a life, and when it reaches its service life, the power will shut off.
There may be abnormal smells and noises generated when the motor parts (carbon brush) wear.
COVER PORTION
Information on the motor life
Stop use of the cleaner and disconnect the power plug before contacting your dealer.
DUST CUP ASSEMBLY
Beating rubber blade
Removing the Beating Rubber Blade
Cleaning the Beating Rubber Blade
Replace the rubber blade with a new one if the rubber blade section is worn.
①
③
②
Gears
Remove the beating rubber blade
from the right side, and slip off
the belt from the gears on the left.
Use scissors to cut off any entangled
thread scraps or hair, etc.
Do not cut the tips of the rubber blade
bristles.
•
Pay attention to avoid injury.
•
Wipe clean with a cloth wetted with water
and wrung well.
Do not use thinners, benzene or hot water
(approx. 40°C or hotter).
•
[ There is a risk of decomposition or deformation. ]
○：
×：
Water-washable
Detergents not permitted
[
There is a risk of malfunctioning. ]
×：
Water-washing
not permitted
○：
○：
Water-washable
Diluted neutral detergent
can be used
The cleaner body cannot be washed with water.
•
Cautions
After washing with water
•
Shake off as much water as possible, and leave in a well-ventilated shady place to dry completely.
[ Failure to dry the rubber blade properly will cause odors or faults. ]
•
Do not dry the rubber blade with hot air, such as with a dryer.
[ There is a risk of deformation or faults. ]
Storage stand (
1 )
•
×
Operation Manual (
1 )
•
×
EC-HX100M_P.indd 3
15/09/25 16:40
