Sharp AR-203E X, Руководство по обслуживанию

Страница: 87 / 176

AR-203E/5420/M200/M201 SIMULATION, TROUBLE CODES 10 - 14
26 04 Machine duplex setup [Function]
When this simulation is executed, the current set duplex is displayed. Enter the code number
corresponding to the desired duplex and press [OK]/[ENTER]/[START] key to save the setting.
[Operation]
The operation is similar to simulation 26-02.
06 Destination setup [Function]
When this simulation is executed, the current set destination is displayed. Enter the code num-
ber corresponding to the desired destination and press [OK]/[ENTER]/[START] key to save the
setting.
[Operation]
The operation is similar to simulation 26-02.
07 Machine conditions check [Function]
When this simulation is executed, the current machine setting is displayed.
[Operation] (AR-M200/M201)
20 Rear edge void setup [Function]
When this simulation is executed, the current set rear edge void is displayed. Enter the code
number corresponding to the desired rear edge void and press [OK]/[ENTER]/[START] key to
save the setting.
[Operation]
The operation is similar to simulation 26-02.
30 CE mark support control
ON/OFF [Function]
When this simulation is executed, the current set CE mark support control is displayed. Enter
the code number corresponding to the desired CE mark support control and press [OK]/
[ENTER]/[START] key to save the setting.
[Operation]
The operation is similar to simulation 26-02.
37 Cancel of stop at developer
life over [Function]
When this simulation is executed, the current setting is displayed. Enter the code number and
press [OK]/[ENTER]/[START] key to change the setting.
[Operation]
The operation is similar to simulation 21-01.
39 Memory capacity check [Function]
When the simulation is executed, the currently installed SDRAM of the main unit is displayed.
[Operation] (AR-M200/M201)
Main
code Sub
code
Contents Details of function/operation
* AR-203E/5420/M200: cannot be executed.
Code number Duplex Display item
0 Duplex NO OFF
1 Duplex YES* ON
* Code number 2 cannot be selected.
Code number Destination Display item
0 Inch series INCH
1 EX Japan AB series AB
2 Japan AB series –
CPM Copy quantity Remark
20 CPM 20
1) The machine setting is displayed.
26-07 CPM
20 CPM
Code number Setting Display item Remark
0 Rear edge void NO OFF
1 Rear edge void YES ON Default
Code number Setting Display item Remark
0 CE mark support control OFF OFF Default (100V series)
1 CE mark support control ON ON
Code number Setting Remark
8 8 MBYTE
16 16 MBYTE
1) Memory capacity display
26-39 MEM.CHK
8 MBYTE