Sharp AQUOS Xx, Руководство пользователя

Страница: 182 / 188

180
Care & Maintenance
・Proper care of Card Slot Cover gasket is crucial for
continued handset water resistance. Observe the following:
・Do not remove or damage gasket. Keep it clean.
・If Card Slot Cover is damaged or deformed, contact a
SoftBank Shop.
・Do not insert a sharp object into Card Slot Cover gap,
Earphones-Microphone Port or External Device Port.
・To maintain water resistance, it is recommended to replace
Card Slot Cover every 2 years regardless of its condition.
Customer-requested Card Slot Cover replacement incurs
fees and requires handset submission. For details, contact
a SoftBank Shop or SoftBank Customer Support,
General
Information .
Washing Handset
Wipe off dirt, sand, beverage, etc., gently with a cloth. Then
hold handset approximately 10 cm below faucet or shower
head and wash with low-pressure tap water (6 liters/min. or
lower) at room temperature (5
o
C - 35
o
C). Wash with your
hands, taking care not to open Card Slot Cover; do not use a
brush or sponge. Dry handset before use; after drying it well,
power on.
・Before washing handset, make sure that Card Slot Cover is
closed firmly.
・Do not use a washing machine or ultrasonic cleaner.
・Earphones-Microphone Port and External Device Port tend to
accumulate dust, sand, etc.; rinse and dry them completely
before use. Any residue may cause malfunction, burns or
fire.
・Do not put a cotton swab, cloth, etc. into Earphones-
Microphone Port or External Device Port; water resistance
may be affected causing malfunction.
Drying Handset
After exposing handset to water, be sure to dry Receiver, Mic,
Recorder Mic, Speaker, Pressure Vent, Earphones-Microphone
Port and External Device Port.
Wipe handset surface with dry cloth
Holding handset firmly by its sides, shake it about 20 times
・When shaking handset, hold it firmly so as not to drop it.
Pat against dry cloth to remove moisture from openings and
grooves
・Water may be trapped in openings; pat against a dry cloth
to remove it.
Leave handset on dry cloth for approximately 2 - 3 hours at
room temperature
Cautions
When Removing Moisture
Do not put a cotton swab, cloth, etc. into openings; water
resistance may be affected.