Sharp AQUOS SH-02L, Инструкция по эксплуатации

Страница: 176 / 242

Infrared communication
„
Receiving data
1
In the standby screen,
z
▶ [Tools] ▶
[Infrared]
2
[Receive one item]
3
Perform sending operation on sender's
device
4
Face the infrared ports of the handset and
receiver's devices
z
Follow the instructions on the screen and operate
after this step.
„
Receiving all data
1
In the standby screen,
z
▶ [Tools] ▶
[Infrared]
2
[Receive all]
3
Enter the authentication code ▶
C
4
Perform sending operation on sender's
device
5
Face the infrared ports of the handset and
receiver's devices
z
Follow the instructions on the screen and operate
after this step.
z
After the operation for receiving, the handset waits to
receive data. Infrared communication automatically
begins when data is sent from sender's device within
approximately 60 seconds.
z
Note that if you select [Delete and register] ▶ [Yes]
when all the phonebook data is received, all the
registered phonebook data will be deleted.
z
Receiving all data may not be available depending on
the data type.
z
When available space in the save destination
becomes insufficient while receiving data, the data
being received to that point are saved and receiving
ends.
174
Data Communication