4
Quick guide
Setting the TV
Bundling the cables
Setting the TV on the wall
•
This TV should be mounted on the wall only with the wall mount bracket available from SHARP. (See page 35.) The
use of other wall mount brackets may result in an unstable installation and may cause serious injuries.
•
When you use the AN-37AG2 (SHARP) wall mount bracket, set the angle of the TV to 0° or 5°. Do not set the angle
to more than 10°.
•
Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting
or mounting that results in accident or injury.
• You can ask a qualified service personnel about using an optional bracket to mount the TV to the wall.
Standard DIN45325 plug
(IEC 169-2)
75-ohm coaxial cable
Antenna
Connect the antenna cable from your antenna-/cable
socket or the (room-/roof) antenna for antenna input
terminal on the back of your TV set to receive digitally/
terrestrially broadcast stations.
An indoor antenna can also be used under good
reception conditions. Passive and active room
antennas are offered commercially. In an active
antenna its power is supplied via the antenna input
terminal.
The supply voltage (5V) must be correspondingly set
under “Supply Voltage”. (See page 18.)
Ferrite Core
The Ferrite Core should be permanently attached and
never removed from the AC cord.
(For Europe, except
U.K. and Eire)
(For U.K. and Eire)
AC cord
Cable clamp (small)
Cable tie
Ferrite Core
Bundle the AC cord
with the clamp
(small).
Cable clamp (large)
Bundle the cables
with the clamp
(large).
Before making any
connections, press
down on the upper
hooks and remove the
rear terminal cover
towards you.
Place the TV close
to the AC outlet, and
keep the power plug
within reach.
LC-32RD2E_GB_a
07.2.1, 5:13 AM
4
