sharkclean .com
sharkclean .com
FILLING THE RESERVOIR
CLEANING MODES
OPEN RESERVOIR LID
VACUUM
WET MOP
STORAGE
After wet cleaning, remove the pad from the VACMOP™ base before storing the unit.
To store the unit, stand it upright and lean the back of the non-slip handle against a wall.
To hang the unit from a nail or wall hook (not included) align the opening at the end of the handle over the
hook or nail.
LEAN AGAINST WALL
HANG FROM HOOK
NOTE:
Once the unit is assembled, do not take it apart, unless for repacking or shipping.
DISASSEMBLY
1.
Press in the snap clip with a small tool
(screwdriver, pen, etc.)
2.
While pressing down on the top snap clip, pull the
handle out of the pole.
3.
Next, press in the snap clip on the VACMOP body
with a small tool.
4.
While pressing down on the bottom snap clip, pull
the pole out of the VACMOP body.
DISASSEMBLE VACUUM HANDLE
DISASSEMBLE VACMOP BODY
1.
3.
2.
4.
Lift the reservoir lid and press it up until it clicks into the open locked position. Carefully pour Shark
VACMOP Cleaner into the reservoir, up to the
MAX
line. When finished, press the lid closed.
For best results, first use the vacuum to remove dry debris, then spray the Shark VACMOP Cleaner to wet mop.
FILL WITH SHARK® VACMOP™ CLEANER
NOTE:
Before using your unit for the first time, carefully add the entire starter bottle of Shark VACMOP Cleaner into the reservoir.
