8
www.sharkclean.co.uk
Care of Your Portable Steam Cleaner
CLEANING THE NOZZLES
1
Your portable steam cleaner should not normally
require cleaning, however, should you notice
a decrease in the steam output, it may be
necessary to remove mineral deposits built up
around the nozzles.
2
Unplug the cleaner from the electrical outlet.
3
Use the provided nozzle cleaner or a small
diameter stiff metal wire, such as a straightened
metal paperclip, and carefully insert the end of
the wire into the nozzle orifice. See illustrations
below. (
fig. 15,
fig. 16
)
4
Move the wire back and forth several times to
remove any deposits.
5
Plug in the appliance to the power outlet and
test to note steam output.
STORAGE
1
Let the appliance cool down before cleaning or
storing.
2
Turn the water tank cap anti clockwise and
remove the cap. Tilt the unit and pour any
remaining water in to the sink or water tight
container. Replace the cap by turning clockwise.
Empty the water tank after each use.
3
Store in a cool dry location.
CLEANING THE STEAM BOTTLE
1
A periodic rinse of your steam cleaner will
help free it from normal water deposits. This
is recommended every 10-15 fillings to free
up any scale deposit. Fill the reservoir with
water and secure the cap. Shake vigorously for
approximately 10-15 times and remove the cap
to empty the reservoir.
Cleaning tip:
To prevent clogging, it is
recommended that you periodically clean the
Concentrator Nozzle and the Accessory Hose
stem with the cleaning tool provided or a paper
clip.
DECALCIFYING YOUR STEAM MOP
Calcium and mineral deposits can build up and impact
the performance of your steam mop over time. To
extend the life of your product we recommend that you
use distilled water.
CARE OF YOUR SCRUBBING PADS
1
We recommend washing your scrubbing pad
separately from other fabrics to avoid picking
up lint.
Only use liquid detergent (no
powder detergent). Do not use any
fabric softeners or bleach.
Line dry. Do not
tumble dry. (
fig. 13
)
2
If there are loose threads on the cleaning pad
carefully cut the thread with scissors. Do not pull
on them or cut at the base.(
fig. 14
)
IMPORTANT
: The scrubbing pad may be very
hot from the steam. Use caution when removing.
Let the unit cool for 2-3 minutes.
fig. 13
fig. 14
40°
fig. 15
fig. 16
SC660UKJR_11_IB_ENG_120523_1.indd 8
12-05-23 1:46 PM
