background image

4

5

IMPORTANT

: First things first, always 

make sure the mop is 

UNPLUGGED

 

from the wall when not in use.  Never 
fill the mop, attach the mop head, 
change or remove the micro-fiber 
pocket when the mop is plugged into 
the wall.  If you have hard water you 
might want to use distilled water to 
prolong the life of the Shark

®

 Steam 

Mop.  Make sure you only add water 
to the tank.  Chemicals or cleaning 
solution may damage the appliance 
and could be unsafe for you and  
your family.

 You can also use the loop to pull the 
dirty pocket off when you are done 
mopping after it has cooled. 

3

  Snap the mop head into the base to 

secure it.

  IMPORTANT

: Don’t use on unsealed 

wood or unglazed ceramic floors.  
On surfaces that have been treated 
with wax or some no wax floors, 
the sheen may be removed by 
the heat and steam action.  It is 
always recommended to test an 
isolated area of the surface to be 
cleaned before proceeding.  We 
recommend that you check the use 
and care instructions from the floor 
manufacturer.

1

  Turn the water tank cap counter 

clockwise and remove from the tank. 

 

Use the filling flask and pour water 
into the tank.  Please don’t overfill. 
Replace the cap on the water tank by 
turning clockwise and tightening.

2

  Select a mop head and cleaning 

pad.  Each mop head can be used 
on your floors.  The Triangle Mop 
Head was specifically designed to 
reach into those tight corners and 
spaces, especially those found in 
the bathroom.  The Rectangle Mop 
Head is completely versatile.  Use 
the lavender loop on the side of the 
micro-fiber cleaning pocket to place 
around the mop head.  Then attach 
the quick fasteners on the top of the 
pocket to secure in place.  

1

2

3

Getting Started - cont’d

Using Your Steam Mop

 

IMPORTANT

: Make sure you don’t 

use the mop without attaching a 
micro-fiber pocket and adding water 
to the tank first.  When you are 
using the mop for the first time, it 
might take longer than the normal 
30 seconds to start steaming.  Just 
pump the handle a few times in a 
downward motion to prime the 
pump and it should be ready. 

2

  Pump the handle a few times in a 

downward motion.  This pumping 
action will release steam as you 
mop and allows you to customize 
the amount of steam you want. 
Begin mopping with a forward and 
backward motion.  The natural 
motion of mopping will produce 
steam.

  NOTE

: Make sure the floors are 

swept or vacuumed before using the 
steam mop. 

1

  Pull and twist the quick release cord 

holder to unwrap the power cord 
completely.  A great time saver!

 

Plug into a 127-volt electrical outlet. 
The power “On” light will turn blue, it 
takes approximately 30 seconds for 
the mop to heat up and the steam to 
be ready.

2

1

S3501BR_11_100505_ENG.indd   4-5

10-05-05   10:30 AM

Содержание S3501BR11












Отзывы: