Shaman MHM-01 Modern Heavy Metal
Article no.: 00034449
Precautions
1) Read these instructions before operating the unit.
2) Please heed all safety warnings and keep these instructions for future
reference. Follow all instructions.
4) Do not use this device near water or moisture.
5) Clean only with dry cloth.
6) Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus that produce heat.
7) Only use attachments/accessories specified by the manufacturer.
8) Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as liquid has
been spilled or objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate normally, or has been
dropped.
9) Battery not included. Use high quality 9V block battery or 9V/DC adaptor
(accessory) for ultimate performance.
Specifications
Shaman MHM-01: Modern Heavy Metal
Input Impedance: 1 M
Ω
Nominal Output:
1,2V
Output Impedance: 1 K
Ω
Output Noise Level: <15mV
Controls:
Pedal Switch, Gain, Level, Mid, Mid Freq, High, Low
LED Indicator:
On/Off (serves also as battery check indicator)
Connectors:
6.35mm Input jack, 6.35mm output jack,
AC adaptor jack 9V/DC
Power Supply:
9 V DC: dry battery 9V type 6F22/9V, AC adaptor
Current Draw:
20mA @ 9V/DC
Dimensions:
80 (W) x 120 (L) x 35/55 (H) mm
Weight:
280 g (battery not included)
1. DV 9V Input
The MHM-01 can be powered by 9V battery or 9V AC/DC adapter. The adapter must
have a barrel connector with center negative. The battery may be left in or taken out
when using an adapter. To install or replace the 9V battery, loosen the screws on the
bottom and remove the bottom plate. Always remember to unplug your guitar cords
from the pedal to conserve battery life. Some battery drain may take place when unit
is plugged in, even if the unit is bypassed.
2. STATUS LED
When the LED is on, the MHM-01 effect is active. When the LED is off, the MHM-
01 is in bypass mode. The footswitch engages/disengages the effect.
3. INPUT Jack
This jack accepts input signals (coming
from a guitar, some other electric or
electronic musical instrument, or another
effects unit).
The INPUT jack also serves as the power
switch. Power is turned on whenever a plug
is inserted into the INPUT jack, and is
turned off when the plug is disconnected.
When not using the unit, you should
disconnect any cord connected to the
INPUT jack.
4. OUTPUT Jack
Connect this jack to your amplifier or some
other electric or another effects unit (input).
5. Pedal Switch
This switch turns the effects ON/OFF.
6. Gain Knob
This knob controls the depth of overdrive
sounds. Rotating the knob clockwise
increases
overdrive
effect,
whereas
counterclockwise reduces the effect
7. Level Knob
This knob adjusts the level of the effect
sound.
8. – 11. EQ Control
This knobs control tone of the effect sound at low/mid/high frequencies.
MID
FREQ
sets middle frequency to 200..2500Hz, Middle/Low/High knobs control the
amount of middle/low/high frequencies.
Musikhaus Kirstein GmbH
Bernbeurenerstr. 11 / 86956 Schongau / Germany
Phone: 0049-8861-909494-0 Telefax: 0049-8861-909494-19
