Page 8
CA-VAT-10-R / SuperHalo Cellular Booster Kit
CA-VAT-10-R / SuperHalo Cellular Booster Kit
Page 7
Step 4. Booster Mount
If mounting booster, mount on vertical location using booster screw fittings.
Step 5. Connect to DC Power
1. The positive red and negative black wired end will connect to watercraft’s power
supply-either battery, ignition or fusebox – whichever is located most conveniently.
2. Connect the DC power cord to the booster.
Turn on switch on power cord.
The Power LED goes ON to show that the booster is ready for use.
The Alert LEDs flash up to 15 seconds on each band to show the band is
place parallel with text above.
If the Power light does not go ON, be sure the power supply is working.
If the Alert LEDs flash after the initial activation period, lower the dial above the blinking
LED by 3dB (for example, from 50 to 47) and monitor the bars on your cell phone to see
whether reception has improved.This process can take a few moments. Monitor the
LEDs to make sure they go off.
If the Alert LEDs continue to flash, the booster will shut down automatically to prevent
oscillation, then restarts after 60 seconds.Turn down the Cellular-800 or PCS-1900 or
LTE(AWS) dial to prevent the booster from shutting down again. Fail to do so, booster
will completely power off after 15 minutes. Manual power reset requires powering off
booster and powering back on. Failure to do so will cause the booster to power off.
INTRODUCTION
INSTALLATION
CA-VAT-10-R / SuperHalo Cellular Booster Kit
Page 9
Note: While the watercraft is in port, the alert light may light up red. This means
that the signal coming into the booster is too strong and it may cause the booster to
shut down. As you move out to sea this will no longer be a problem.