Shakespeare Electronic superhalo CA-VAT-10-R, Руководство пользователя, Страница: 7 / 13

INTRODUCTION
Page 6
CA-VAT-10-R / SuperHalo Cellular Booster Kit CA-VAT-10-R / SuperHalo Cellular Booster Kit
Page 5
INSTALLATION
CA-VAT-10-R / SuperHalo Cellular Booster Kit
Page 7
OPTION 2
1. When location of outside antenna has been determined, remove cap from ferrule
side hole.
2. Feed FME connector (small end) and cable through side hole on the ferrule as
shown in figure below.
3. Feed remainder of cable through ferrule hole until approx. 1” of cable remains.
4. Connect N connector to antenna.
5. Screw antenna onto ferrule,bend cable to prevent cable from twisting.
6. Screw base onto other end of ferrule.
7. Mount base onto location.
FME connector
1
2
N connector
Step 2. Using the CM240-M cable
Use the CM240-M cable FME connector to connect the outside antenna to the
booster connector marked OUTSIDE (see page 2).
Make sure to not coil additional coax cable that might be left over from installation.
Hand tighten the connection.
3