Problem 6:
The Steam produced is not hot enough
Solution 6:
Please don
’
t worry, this is normal:
the steam temperature drops rapidly
with the lengthening of the distance. When you use the steam cleaner, please keep
the steam nozzle close to the surface of the object (<3cm/1.18 inch), the cleaning
effect is better .
Note that do not touch the steam nozzle with your hands during use, please pay
attention to safety when using.
Solution 7:
When the temperature is low, especially in cold winter, please place the
machine in a warm room for 3-5 hours before each use. Otherwise the residual
water in the main body will freeze and block the machine.
Solution 8:
if you encounter any problem during use, please feel free to contact us.
Our Service email : [email protected]. Thank you!
6. Troubleshooting and maintenance
Fault Phenomenon
Causes of the Failure
Troubleshooting
The machine is overheated
or smokes
1. It is caused by the insulation
cotton of the roasting equipment;
2. the equipment does not absorb
water
or
insufficient
water
absorption.
Stop the machine for 20
minutes and wait for the
machine to cool down before
use,
make
sure
the
equipment can absorb water
and the humidity is adjusted
to the maximum
3. The host switch light
does not light up after
plugging in
Loose or defective plug
Check whether the power
strip is energized and the
carrying voltage needs to be
able to carry the power strip
above 2500W
Machine switch problem
Need to replace switch
The
spray
gun
automatically shuts down
or the steam output is
small
Scale blockage
Twist the steam outlet pipe
to see if the main engine
can discharge steam, and
clean the scale on the inner
wall of steam outlet
Water
leakage
in
extended stainless steel
elbow
Damaged rubber ring
Put an extra rubber ring or
replace with a new rubber
ring and tighten
