SEW DRC.-...-DAC, Руководство по эксплуатации

Страница: 78 / 252

78
Operating Instructions – Electronic Motor DRC.-..-DAC
6
Startup with binary slave GLK30A in "Easy mode"
Startup
6.6.3 Data AS-Interface master → inverter
The following table shows the 4 data bits that the AS-Interface master sends to the DRC
inverter via the AS-Interface:
6.6.4 Inverter data → AS-Interface master
The following table shows the 4 data bits that the DRC inverter sends back to the AS-
Interface master via the AS-Interface:
AS-Interface bit Function
DO0 CW/stop
DO1 CCW/stop
DO2 Speed f2/speed f1
DO3 Reset
1)
/ controller enable
1) In the event of an edge change "0" → "1" (only effective in case of an error)
INFORMATION
To enable the drive, AS-Interface bit DO3 "Reset/controller enable" must be set.
Bit Function
DI0 Ready signal
0: The DRC drive is not ready for operation
1: The DRC drive is ready for operation
DI1 Manual mode/local mode
0: DRC control via AS-Interface
1: DRC control via manual mode
DI2 Sensor input 1
0: The signal of sensor 1 = "0"
1: The signal of sensor 1 = "1"
DI3 Sensor input 2
0: The signal of sensor 2 = "0"
1: The signal of sensor 2 = "1"
00
I