SEW-Eurodrive MOVITRANS TES31A, Руководство по эксплуатации продукта

Страница: 26 / 72

5
Single-point synchronization
Requirements
Product Manual – MOVITRANS
®
TES31A Decentralized Supply Unit Synchronization
26
5 Single-point synchronization
5.1 Requirements
5.1.1 General information
The project planning of a MOVITRANS
®
system calls for specified knowledge ex-
plained in this documentation.
The following information is based on the general guidelines that apply to project plan-
ning. This documentation is drawn up for users that are familiar with and have basic
knowledge of drive project planning.
5.1.2 PC and software
The "Single-point synchronization" function is part of the unit firmware. You will need
the SEW‑EURODRIVE software MOVITOOLS® MotionStudio for configuring the sup-
ply units.
5.1.3 Supply unit
The "Single-point synchronization" function can be implemented only with supply units
with the power 14 kW and 16 kW. Control is possible either via terminals or bus. The
selection of the unit type depends on the project-planned transmission system (fre-
quency, power, line cable current).
5.1.4 Permitted operating modes
In the single-point synchronization mode, only the "Current control" operating mode is
permitted.
INFORMATION
For more information on the operating modes, refer to the following documentation:
MOVITRANS® TES31A Decentralized Supply Unit
29190657/EN – 04/2020