SEW-Eurodrive MOVIPRO PHE Series, Руководство по эксплуатации, Страница: 71 / 100

8
Operation
Status and error messages
Operating Instructions – MOVIPRO
®
PHE..B-A15-.1X0..B-00
71
8.4 Status and error messages
The status display of the device displays the following information depending on para-
meterization and operating state:
• In automatic operation:
– Active drive command or active drive command and speed limitation
• in manual operation:
– Active command
• In error status:
– Err or ErP
– Error code
• When establishing a connection with the IR remote control:
– Vehicle ID
• In all other operating states:
– Operating state
For detailed information about possible status messages, refer to the relevant soft-
ware documentation and the project description of the system solution, chapter "Oper-
ation".
8.4.1 List of faults
In case of a malfunction, the status display of the device displays the following error
codes.
Code Meaning Possible cause Measure
302 Overcurrent
• Short circuit at frequency in-
verter output • Check the connection between the
frequency inverter output and the
motor as well as the motor winding
for short circuits.
• Reset the fault by switching off the
DC 24 V supply voltage or resetting
the error.
303 Thermal overload of
the output stage or
internal device error
• Heat sink is dirty • Clean the heat sink.
• Reset the fault by switching off the
DC 24 V supply voltage or resetting
the error.
• Ambient temperature too high • Lower ambient temperature.
• Reset the error by switching off the
24 V supply voltage or via error re-
set.
• Heat build-up in frequency in-
verter • Prevent heat build-up.
• Reset the error by switching off the
operating switch.
• Drive load too high • Reduce the load on the drive.
• Reset the error by switching off the
operating switch.
23576855/EN – 10/2017