SEW-Eurodrive Movigear Performance MGF**-DFC-C Series, Руководство по эксплуатации, Страница: 288 / 416

9
Inspection and maintenance
Inspection and maintenance work
Operating Instructions – MOVIGEAR
®
performance
288
Filling in the oil
1. Observe the notes in chapter "Preliminary work for inspection and maintenance".
2. SEW‑EURODRIVE recommends that you fill in the new oil in the position depicted
in the figure below.
3. NOTICE! Filling in the wrong oil may result in significantly different lubricant char-
acteristics. Potential damage to property. Do not mix different synthetic lubricants
and do not mix synthetic and mineral lubricants. Synthetic oil is used as the stand-
ard lubricant.
Fill in new oil of the same type via the lower bore hole [2].
ð The oil viscosity and type (synthetic) that are to be used are determined by
SEW‑EURODRIVE specifically for each order. This information is noted in the
order confirmation and on the drive unit's nameplate.
ð
It is easier to fill in the oil when you also remove the upper breather plug [1] or
breather valve installed there (air can flow out).
ð For the required oil quantity, refer to the nameplate or the chapter "Technical
data and dimension sheets / Lubricants" depending on the mounting position.
4. Re-insert the screw plug and the breather valve. Depending on the mounting posi-
tion used, observe the mounting position sheet.
5. Touch up or renew the surfaces / anti‑corrosion coating.
Recommended position
The following figure shows the position recommended for filling in the new oil:
[1]
[2]
25402429067
25945475/EN – 04/2019