SEW-Eurodrive Movigear Performance MGF**-DFC-C Series, Руководство по эксплуатации, Страница: 120 / 416

5
Electrical installation
PC connection
Operating Instructions – MOVIGEAR
®
performance
120
Connection to X4141 (M12 at the connection box)
The engineering interface X31 in the connection box of the drive unit is assigned to
the internal wiring of plug connector X4141.
[1] [3] USB
[2]
X4141
9007224819186315
[1] USB 2.0 connection cable
(commercial, included in the delivery of USM21A)
[2] Interface adapter USM21A
[3] Connection cable RJ10/M12
(available for delivery from SEW‑EURODRIVE, part number: 28111680)
Installing the included engineering plug connector X4141
The engineering plug connector X4141 is usually delivered by SEW‑EURODRIVE in
an accessory bag (part number: 28258185) together with the drive unit. In this case,
install the engineering plug connector X4141 to the connection box of the drive unit as
follows:
1. It is essential that you observe the startup instructions.
2. Switch off the voltage supply and wait for at least 5 minutes.
3. Loosen the screws and remove the electronics cover from the connection box.
4. Plug in the plug connector RJ10 from outside through one of the permitted cable
entry bores (for the permitted positions, see the chapter "Plug connector posi-
tions"). Push the cable completely into the connection box.
5. Screw plug connector M12 into the cable entry bore. Fasten the nuts of the M12
plug connector (tightening torque: 6 Nm).
25945475/EN – 04/2019