SEW-Eurodrive MOVIFIT FC, Руководство по эксплуатации, Страница: 68 / 228

5
Electrical installation
Standard ABOX MTA...-S02.-...-00
Operating Instructions – MOVIFIT
®
FC
68
X8, X81, X9 and X91: Motor connection terminals
WARNING
Risk of crushing due to incorrect parameterization of the digital output DB00.
Severe or fatal injuries.
• If digital output DB00 is used to control the brake, do not change the parameters
that define the functions of the digital output.
• Check the parameter settings before using the digital output to control the brake.
1
11 11 12 12 13 13 14 1415 15 16 16
2 3 4 5 6
17 1718 18
7 8
X29
1 2 3 4
X91
S3
1
11 12 13 14 15 16
2 3 4 5 6
X20
1 2 3 4
11 12 13 14
X1
11
1 2 3 4 5 6 7 8
12 13 14 15 16 17 18
31 32 33 34 35 36 37 38
21 22
11
1 2 3 4 5
12 13 14 15
31 32 33 34 35
21 22 23 24 25
11
1 2 3 4 5
12 13 14 15
23 24 25 26 27 28
X45 X25
X35
X50
5 6 7
5
1
1 2 3 4
2 3 4
1 2 3 4
6 7
X81
X8
X9
812534411
Motor connection terminals (connection via hybrid cable)
No.
Name Function for motor with SEW stand-
ard brake Function for motor with 2-wire constant DC
brake
1)
X8 1 PE Motor PE connection
2 U Motor phase U output
3 V Motor phase V output
4 W Motor phase W output
5 15 SEW brake terminal 15 (blue) DC brake connection (+)
6 14 SEW brake terminal 14 (white) No function
7 13 SEW brake terminal 13 (red) DC brake connection (-)
X81 1 TF+ Connection for TF temperature sensor / TH temperature switch (+) motor 2)
2 TF- Connection temperature sensor TF/temperature switch TH (-) motor 2)
3 DB00 Digital output "Brake released" = Factory setting (switching signal 24 V)
4 0V24_C 0V24 reference potential for brake output
X9 1 PE PE connection
2 - Reserved
3 - Reserved
4 - Reserved
5 -R Braking resistor connection "-R"
6 - Reserved
7 +R Braking resistor connection "+R"
X91 1 – 4 - Reserved
1) Before starting up the MOVIFIT® FC drive with constant DC brake, you must connect an additional external braking resistor to the
MOVIFIT® inverter.The braking resistor is used to dissipate the regenerative energy.
2) With motor without TF/TH, jumper X81/1 terminal must with X81/2 terminal.Then activate the electronic motor protection by setting
the parameter P340 and P342 to "ON".
21316996/EN – 12/2014