SEW-Eurodrive MOVI-PLC basic DHP11B-T0, Руководство пользователя

Страница: 38 / 96

4
Project Planning and Startup
Configuring a PROFIBUS-DP master
38
Manual – MOVI-PLC
®
basic DHP11B.. controller
4.4 Configuring a PROFIBUS-DP master
You require a GSD file for configuring a PROFIBUS-DP master for the MOVI-PLC
®
basic DHP11B.. controller
GSD file for
PROFIBUS-
DP/DP-V1 The GSD file SEW_6007.GSD corresponds to GSD revision 4. The unit master data
files, which were standardized by the PROFIBUS Nutezerorganisaton [users' organi-
saton], can be read by all PROFIBUS-DP masters.
Project planning
procedure Proceed as follows to configure the MOVI-PLC
®
basic DHP11B.. controller with the
PROFIBUS-DP interface:
1. Read the
README_GSD6007.PDF file, which you receive with the GSD file for
further current information on configuration.
2. Install (copy) the GSD file according to the requirements of your configuration soft-
ware (
Æ
manual for your configuration software or section "Installing the GSD file in
STEP7", below). Once the file has been installed correctly, the unit appears next to
the slave stations with the designation
MOVI-PLC .
3. Add the MOVI-PLC
®
basic DHP11B.. controller under the name MOVI-PLC to the
PROFIBUS structure and assign the PROFIBUS station address.
4. Select the process data configuration required for your application (
Æ
Section "DP
Configuration").
5. Enter the I/O or peripheral addresses for the configured data widths.
After project planning you can start PROFIBUS-DP. The
Fault Profibus LED indicates
the status of the project planning (OFF => project planning OK).
Installing the
GSD file in STEP7 Proceed as follows to install the GSD file in STEP7:
1. Start the Simatic Manager.
2. Open an existing project and start the hardware configuration.
3. Close the project window in the HW Config. You cannot install a new file version if
the project window is open.
4. In the menu click on "Extras" / "Install new GSD..." and select the new GSD file with
the name SEW_6007.GSD.
The software installs the GSD file and the associated bitmap files in the STEP7 system.
The current version of the GSD file for the MOVI-PLC
®
basic DHP11B.. controller is
available on the SEW homepage (http://www.sew-eurodrive.de) under the heading
"Software".
Project planning tool DP master File name
All DP project planning tools to IEC 61158 for DP master standard SEW_6007.GSD
Siemens S7 hardware configuration for all S7 DP masters
Do not change or expand entries in the GSD file! SEW assumes no liability for MOVI-
PLC
®
or connected inverter malfunctions caused by a modified GSD file.
0 0
I