2
Safety notes
Preliminary information
Assembly and Operating Instructions – Parallel Arm Kinematics Kit
8
2
Safety notes
2.1
Preliminary information
The following basic safety notes must be read carefully to prevent injury to persons
and damage to property.
The safety notes refer to the use of the system solution described in this document.
This document does not replace the detailed documentation of the products and soft-
ware used. You therefore have to observe the documentation of the products and soft-
ware used.
Ensure that all safety notes are observed.
2.2
Working on the system solution
Make sure that all work steps described in this documentation are only performed by
qualified specialists.
Observe the following:
•
National and regional safety and accident prevention regulations
•
Personal protective equipment, e.g. safety shoes
•
Caution signs on the products
•
All system-specific specifications and conditions
The system solution may only be operated in systems equipped with the required
monitoring and protection devices.
2.3
Target group
Planning and
design
Any work related to planning and design which is necessary for the correct integration
of the drive solution into the machine/system may only be performed by adequately
qualified personnel. Qualified personnel in the context of this documentation are per-
sons familiar with the mechanical or electromechanical design, integration of the drive
solution into the plant/machine and the corresponding processes (e.g. hazard analysis
and risk assessment) and who have the following qualifications:
•
Qualification in the electrotechnical area in accordance with the national regula-
tions
•
Qualification in the mechanical area in accordance with the national regulations
•
Knowledge of this documentation and other applicable documentation.
Specialist for
mechanical work
Any mechanical work may only be performed by adequately qualified specialists. Spe-
cialists in the context of this documentation are persons familiar with the design,
mechanical installation, troubleshooting, and maintenance of the product who possess
the following qualifications:
•
Qualification in the mechanical area in accordance with the national regulations
•
Familiarity with this documentation
25797530/EN – 04/2018
