2
Safety notes
Protective separation
Assembly and Operating Instructions – Parallel Arm Kinematics Kit
11
Make sure that preventive measures and protection devices comply with the applic-
able regulations (e.g. EN 60204-1 or EN 61800-5-1).
2.9.1
Required preventive measure
Make sure that the product is correctly attached to the ground connection.
2.9.2
Stationary application
Necessary preventive measure for the product is:
Type of energy transfer
Preventive measure
Direct power supply
•
Ground connection
2.10
Protective separation
The product meets all requirements for protective separation of power and electronics
connections in accordance with EN 61800-5-1. To ensure protective separation, all
connected circuits must also meet the requirements for protective separation.
2.11
Startup and operation
Damaged products
Never install damaged products. Submit any complaint to the shipping company im-
mediately in the event of transportation damage. Do not start up damaged products.
Monitoring and
protection devices
Do not deactivate monitoring and protection devices even for a test run. Switch off the
devices if in doubt whenever changes occur in relation to normal operation (e.g. in-
creased temperature, noise, vibration). Determine the cause. It may be necessary to
contact SEW‑EURODRIVE.
The machine or system manufacturer must equip machines/systems in which such
devices are installed with additional monitoring and protection devices in accordance
with the respective applicable safety regulations, e.g. the law governing technical
equipment, accident prevention regulations, etc.
Additional preventive measures may be required for applications with increased haz-
ard potential. You must check the functionality of protection devices each time you
change the configuration.
Cover unused connections with the supplied protection caps during operation.
Depending on the degree of protection, the devices have:
•
Live parts
•
Bare parts
•
Moving and/or rotating parts
•
Hot surfaces
25797530/EN – 04/2018