SEW-Eurodrive DH 21B Series, Руководство пользователя, Страница: 9 / 92

2 Safety notes
Preliminary information
Manual – DHE/DHF/DHR21B (standard) and DHE/DHF/DHR41B (advanced)
9
2 Safety notes
2.1 Preliminary information
The following general safety notes have the purpose to avoid injury and damage to
property. They primarily apply to the use of products described in this documentation.
If you use additional components also observe the relevant warning and safety notes.
2.2 Use
Make sure that the basic safety notes are read and observed. Make sure that persons
responsible for the machinery and its operation as well as persons who work on the
device independently have read through the documentation carefully and understood
it. If you are unclear about any of the information in this documentation, or if you re-
quire further information, contact SEW‑EURODRIVE.
The following safety notes refer to the use of the software.
This document does not replace the detailed documentation for the connected
devices. This documentation assumes that the user has access to and is familiar with
the documentation for all connected products.
Do not perform installation or startup if the product is damaged.
Removing required covers without authorization, improper use or incorrect installation
and operation may result in severe injury to persons, or damage to machinery.
All work in the areas of transportation, storage, operation and waste disposal must be
carried out by persons who are trained appropriately.
2.3 Target group
Specialist for
mechanical work Any mechanical work may only be performed by adequately qualified personnel. Qual-
ified personnel in the context of this documentation are persons familiar with the
design, mechanical installation, troubleshooting and maintenance of the product, who
possess the following qualifications:
• Qualification in the field of mechanics according to applicable national regulation.
• They are familiar with this documentation
Specialist for elec-
trotechnical work Any electronic work may only be performed by adequately skilled persons (electric-
ally). Qualified electricians in the context of this documentation are persons familiar
with electrical installation, startup, troubleshooting and servicing of the product who
possess the following qualifications:
• Qualification in the field of electrical engineering according to applicable national
regulation.
• They are familiar with this documentation
In addition to that, these persons must be familiar with the valid safety regulations and
laws, as well as with the requirements of the standards, directives and laws specified
in this documentation. The above mentioned persons must have the authorization ex-
pressly issued by the company to operate, program, configure, label and ground
devices, systems and circuits in accordance with the standards of safety technology.
Instructed persons All work in the areas of transportation, storage, operation and waste disposal must be
carried out by persons who are trained appropriately. The purpose of the instruction is
that the persons are capable of performing the required tasks and work steps in a safe
and correct manner.
22900055/EN – 08/2016