SEW-Eurodrive CMP40 - 112, Руководство по эксплуатации

Страница: 8 / 32

2 Safety notes
Preliminary information
Addendum to the Operating Instructions – Synchronous Servomotors CMP40 – 112, CMPZ71 – 100
8
2 Safety notes
2.1 Preliminary information
The following basic safety notes must be read carefully to prevent injury to persons
and damage to property. The user must ensure that the basic safety notes are read
and observed. Ensure that persons responsible for the machinery and its operation as
well as persons who work on the unit independently have read through the document-
ation carefully and understood it. If you are unclear about any of the information in this
documentation, or if you require further information, contact SEW‑EURODRIVE.
The following safety notes are primarily concerned with the use of the unit described in
these operating instructions. If you use other components from SEW‑EURODRIVE,
also refer to the safety notes for these particular components in the corresponding
documentation.
Also observe the additional safety notes provided in the individual chapters of this doc-
umentation.
2.2 Target group
The document is for everyone who plans, configures and starts up safety-rated en-
coders in motors.
Any work with the software may only be performed by adequately qualified personnel.
Qualified personnel in this context are persons who have the following qualifications:
• Appropriate instruction.
• Knowledge of this documentation and other applicable documentation.
• SEW‑EURODRIVE recommends additional product training for products that are
operated using the respective software.
Any mechanical work on the components may only be performed by adequately quali-
fied personnel. Qualified personnel in the context of this documentation are persons
familiar with the design, mechanical installation, troubleshooting and maintenance of
the product, who possess the following qualifications:
• Training in mechanical engineering, e.g. as a mechanic or mechatronics technician
(final examinations must have been passed).
• Knowledge of this documentation and other applicable documentation.
All electrical work on connected units is to be performed exclusively by adequately
qualified electricians. Qualified electricians in the context of this documentation are
persons familiar with electrical installation, startup, troubleshooting and maintenance
of the product, who possess the following qualifications:
• Training in electrical engineering, e.g. as an electrician or mechatronics technician
(final examinations must have been passed).
• Knowledge of this documentation and other applicable documentation.
• Knowledge of the relevant safety regulations and laws.
• Knowledge of all other standards, directives and laws named in this documenta-
tion.
The above mentioned persons must have the authorization expressly issued by the
company to install, operate, program, configure, label and ground units, systems and
circuits in accordance with the standards of safety technology.
All work in the areas of transportation, storage, operation and waste disposal must be
carried out by persons who are trained appropriately.
22491465/EN – 03/2016