Instruction Manual for ATC250 “AQUA TRAILER”
Congratulations on your purchase of your new “AquaTrailer”, we take pride in bringing you a
quality product which will offer you years of service and enjoyment, your new “Aqua Trailer” is an
investment which deserves your care and attention.
The Aqua Trailer was designed to transport cargo by water by towing it behind a small boat or a
PWC (personal water craft). It can also be fastened to your vehicles roof rack, (please check your
vehicles owners manual for proper attachment and load capacity).
Before you proceed, be sure to read and understand the instructions printed on the “Aqua Trailer”
as well as on this Owner’s Manual.
Inflation Procedures
1. Unfold your new “Aqua Trailer” in an area that is free of sharp objects and debris.
2. Unfold the nylon cover and the PVC bladder.
3. Slide the PVC bladder into the nylon cover making sure to line up the handles and the main
valve to the openings on the nylon cover.
4. Install the EVA foam pad inside the floor of the Aqua Trailer, slide the EVA foam pad through
the large opening located towards the rear of the floor.
5. Inflate your “Aqua Trailer”, with an inflator such as a bellows foot pump, hand pump, electric
inflator or any other inflator designed for inflatable boats, rafts, pool floats, air beds, camping
mattresses, and other low pressure inflatables. These types of inflators will have a hose and
adapters to fit the valves on this product.
6. Follow order of inflation as indicated by the printed numbers next to the valves.
Note:
Any use of an air compressor will damage your product and automatically void all warranties
Towing System
The “Aqua Trailer” features a towing system with a Quick Hitch, be sure to connect the tow rope
according to the instructions provided below.
Figure # 1
Figure # 2
Slide the loop of the tow rope through the
Slip the loop of the tow rope
Opening of the Quick Hitch. (Figure # 1)
through the center opening on
the Quick Hitch, (Figure #2).
Figure
#
3
Figure
#
4
Slide the loop around each one of the side
Pull the the tow rope tight making sure
openings on the Quick Hitch. The tow rope
that the loop goes over the knot.
should stay in place due to the special design
(Figure # 4)
of the Quick Hitch. (Figure # 3)
