Wifi Button
Action Button
Alarm (Red) LED
Alarm (Green) LED
Infrared LEDs
Power and Diagnostic LEDs
SRF600 Quick Start Guide
The
Wifi Button
has several functions:
1. Press and hold for one second. The
Activity (Green) LED
will flash
once to acknowledge the button press and you will hear a beep.
The tran smitter will attempt to connect to the SetraEDGE™ and
send any unsent data and/or receive any new tasks. During this
time the lower segment of the
WiFi Signal
Icon
will flash.
2. Press and hold for five seconds. The transmitter will go into
Survey Mode
and check the WiFi Signal Strength. To exit press
the
WiFi Button
again.
3. The LCD will display “SUr” and then switch to display negative
numbers.
Values above -59dB are good to excellent - 4 bars on the LCD
Values in the range -60 to -79 dB are OK - 3 bars on the LCD
Values below -80dB are poor - 2 bars on the LCD
4. Press and hold the
WiFi Button
and
Action Button
simultaneously
for five seconds to place the transmitter into
Setup Mode
. Press
the WiFi Button again to exit Setup Mode.
The
Action Button
allows you to navigate between Active Channels.
1. Press once to change the
Active Channel
that is displayed.
2. Press and hold the
Action Button
and
WiFi Button
simultaneously for five seconds to place the transmitter into
Setup Mode.
The
Alarm (Red) LED
will flash whenever one or more channels is in
an active (unacknowledged) alarm state. It will not flash for
High
and
Low Warning
states, but will flash for
High
and
Low Alarm
states.
The
Activity (Green) LED
will flash briefly every second to indicate that the
transmitter is operating normally. The
Activity (Green) LED
will also flash
once whenever the WiFi Button has been operated.
The
Infrared LEDs
are only used during the manufacturing process and
do not display or have any significance in normal operation.
These illuminate at various times depending on transmitter interactions.
1. Green - If the RF520 Mains PSU is plugged in then GREEN LED will
illuminate
2. Yellow - The YELLOW LED indicates that the Transmitter is attempting to
connect to the WiFi
3. Red - When the RED LED illuminates then the Wi-Fi card is active
If both the Red and Yellow LEDs are illuminated, then the Transmitter is
communicating with SetraEDGE.
Also Included:
Mounting Bracket
Use the supplied mounting bracket to
secure the transmitter to a suitable
surface using appropriate fixings (not
supplied).
Cable Ties
Use these to tidy and secure
any cables post-installation and
prevent cables from pulling out
of their sockets.
Activity (Green) LED
Activity (Red) LED
Action Icons
Fault Alert
WiFi Signal
WiFi Button
Action Button
Integral Thermistor Sensor*
(*Not SRF614)
(*The internal Channel on SRF614 is inside the Lumberg Plug)
Door Sensor Alert
Infrared LEDs
Scale Selected
Low Battery Indicator
Power and
Diagnostic LEDs
Mounting Plate
Alarm Active Alert
Current Active Alert
High/Low Alarms
2-Pin Power Supply Socket
3-Pin Power Sensor Socket
6-Pin Lumberg Probe Socket
