SES SAT DBPX, Руководство пользователя/инсталлятора

Страница: 30 / 36

SAT DBRX V1.0 INSTALLATION AND USER GUIDE
26
CALLING XXXX
information one after the other:
NAME
PHONE #
ADDRESS
CITY
STATE
NOTE L1
NOTE L2
SAT ID, TIME AND DATE
If a field is inadvertently skipped, simply continue to press the "#" key and the database will
wrap around until the desired line (or field) shows on the display.
After 5 seconds, or after the SAT transmits its' ID, the microphone will be active, and two way
voice communication is possible.
7.2
TERMINATING A CALL
There are three ways in which a call received from a SAT may be terminated.
1) By hanging the handset on the cradle. This will transmit a disconnect tone to the SAT.
2) By exceeding the length of time that the SAT is set to time out. SATs can be set for 1, 4,
8, 16, or 64 minutes, depending on the jumper JP13 selection on the SAT. At the
end of this time
it is the SAT that disconnects and terminates the call.
3) By pressing the "#" key on the keypad after placing a call to a SAT, and after the keypad
is active. You can only do this before the SAT transmits its' ID. Once the ID has been transmitted,
the "#" key scrolls through the data base.
After any call termination the SYSTEM READY message will return to the LCD display.
7.3
PLACING A CALL TO A SAT
To call a SAT from the SAT DBRX, lift the handset from the
cradle. The SAT DBRX will display "CALLING" as shown at left. Dial
in the ID number of the SAT you wish to call. The display will show the
ID selected on the display. The SAT DBRX will dial the phone number
programmed into the ID database for that SAT. (See section 4.1.1.3).