Servomex 02500003E, Быстрый старт

Страница: 10 / 33

Servomex 2500 Quick Start Manual
10 2500 Series - Configuration and Operation 02500/003E/0
will often be necessary to enter the password.
NOTE
The factory-default password for the 2500 series is ‘2000’ - this must be entered.
Alternatively, if a keyswitch has been fitted this should now be closed. Failure to close
the keyswitch is interpreted as an invalid password, and this should prompt the user to
operate the keyswitch at this point.
NOTE
The ‘up arrow’ (
↑
) appears at the lower right of the display. This arrow is used
throughout the 2500 software to indicate that more information, or further items for
selection, are available and can be viewed by pressing
the ▲ key. A ‘down arrow’
(
↓
)
means further informatio
n in the ▼ direction, and a ‘double headed’ arrow
(
↕
) indicates
more information in either direction.
2.3 Setting passwords
NOTE
If the keyswitch facility is to be used, ignore this section.
Several sections of the 2500 menu are password-protected against unauthorised
changes by a 2-level password system. A lower-level OPERATOR password protects
basic calibration functions, and a high-level SUPERVISOR password protects the
essential configuration functions. The factory default password is ‘2000’ in both cases.
At this stage, new passwords may be selected.
NOTE
•
Be sure to record the chosen passwords in a safe place.
•
Three consecutive failed attempts at entering a password will cause a fault to be
signalled.
•
The numbers can be scrolled round completely using the cursor keys, and the
decimal point (.) and minus sign (-) are included in the character set.