SerVision MVG200, Руководство по настройке и управлению, Страница: 24 / 241

SerVision Embedded Video Gateway System Guide
Configuring System Settings 23
 Field  Description
Disable TV-Out while
Downloading Select this option to stop streaming to the CCTV monitor connected to the Video
Gateway while downloading of recorded video to a PC is taking place.
Note: This field only appears if Download Optimizations is enabled and if TV-
Out is enabled (see
Configuring a CCTV Monitor (TV-Out)
, page 25).
Video Authentication Select this option if you want the system to include a digital signature in each video
frame streamed and/or recorded by the unit. The signature can be used to identify
streams that were tampered with.
Note: This option increases the load on the system resources slightly, so it is
advisable to activate it only if it is truly required.
Outline Switching Select one of the following types of triggers for activating different outlines:
 None: No automatic outline switching – outlines can only be
switched manually using the configuration utility (see
Defining
Alternate Outlines, page 149)
 Sensor: Makes it possible to use Sensor 1 events as triggers for
outline switching (see
Configuring Sensor and Activator
Settings,
page 119)
Note: For CVG and CVG-M models, this option should not be selected if
the sensor connector ( In1 ) is used to control the display on a connected
CCTV monitor. For additional information, please refer to the unit’s
installation guide.

Schedule: Makes it possible to schedule outline switching (see
Schedules
, page 76)
Network Speed
Optimization
If video from the unit will be viewed primarily or exclusively on PCs that are on the
same LAN as the unit, select this option to minimize the streaming delay within the
LAN. That is, when this option is selected, live video will be played as close to real
time as possible.
Clear this option if live video will be viewed remotely via the internet or a modem
connection.
Network TCP
Optimization If video from the unit will be transmitted primarily or exclusively to client devices
that are
not
on the same LAN as the unit, select this option to minimize the
streaming delay. That is, when this option is selected, live video will be played as
close to real time as possible.
Clear this option if live video will be viewed primarily on devices that are on the
same LAN as the Video Gateway.
SMS on System Start Select this option if you want the unit to send SMS notifications whenever it starts
running.
SBox Sensors
(MVG and CVG-M
only)
[Not currenty in use.]
ADAM Sensors If sensors are connected to the unit through an ADAM module, select Enabled .
This makes it possible to activate and configure the sensors. For additional
information, see
Configuring Sensor and Activator
Settings, page 119.
IA Activators Used If activators are connected to the unit through an IA relay board, select the number
of activators that are connected to the board. For additional information, please
refer to the unit’s installation guide.