SerVision MVG200, Руководство по настройке и управлению, Страница: 198 / 241

SerVision Embedded Video Gateway System Guide
Resetting the Unit 197
Resetting the Unit
You can reset the unit at any time. Resetting the unit may help if video streaming is unreliable or frequently
interrupted. In addition, most configuration changes you make are only fully implemented after the unit is reset. If
changes were made to the configuration of the unit, and the changes were saved on the unit, but the unit was not
reset afterwards, the changes are implemented when the unit is reset. Resetting does not cause any settings to be lost
or restored to their default values.
The unit can be reset in one of the following ways:

Through the configuration utility

By unplugging the unit from the power
On MVG and UVG400 units, resetting the unit also resets the router. If you wish, you can reset the router without
resetting the unit. While the router is restarting, you will not be able to connect to unit, but it will continue to record
video and event information.


 To reset the unit using the configuration utility:
1. Log into the configuration utility (see Opening the Configuration Utility , page 8).
2. In the
Main Menu
, under System , click Restart . The
System Restart Page
opens.
3. Click Restart System . The unit restarts.


 To perform a power reset:

Unplug the unit from the power and then plug it in again.


 To reset a SerVision router:
1. Log into the configuration utility (see Opening the Configuration Utility , page 8).
2. In the
Main Menu
, under System , click Restart . The
System Restart Page
opens.
Figure 240: System Restart Page with Restart Router button
3. Click Restart Router . The router restarts.