Sercomm DBC831V2, Руководство по установке, Страница: 12 / 22

10
Chapter 3
Hardware Installation
This chapter covers the most likely problems and their solutions.
Overview
Note: Ensure the camera is configured and enrolled in AP or router before permanently
mounting.
Note: If DBC831v2 is using for engineering develop purpose, it is available to use Mirco USB
cable to charge the battery for replacing the transformer. And doorbell does not require
attaching with the chimer.
Note: For DBC831v2 installation, doorbell must be attached with indoor chimer and
transformer use for power supply loop. (While mounting regular bracket, it must use 8-24V
transformer to power up doorbell; while mounting Always on bracket, it must use 16-24V
transformer to power up doorbell)
1. Check the voltage at the chimer to ensure voltage is between 8 ~ 24V AC(for mounting
Always on bracket, the voltage should be 16~24V).
2. Turn off the breaker circuit before disconnecting legacy doorbell button.
3. Unscrew the legacy doorbell to locate two power wires. (The recommended installation
height is between 47 -60 inches.)
3