Sequid DTDR-65, Руководство по эксплуатации, Страница: 42 / 111

5.4 General Remarks on reloading TTC/12TC Data
•
The last known TTC/12TC is loaded automatically on program startup,
if activated in the Options Window
→
Device tab.
•
The last available TTC/12TC can easily be reloaded by opening the TTC-
Wizard and pressing the Reload button.
•
The software shows a warning, if the loaded TTC/12TC is older than
14 days. This value can be changed in the Seunis.config (see section
3.2 ) file by editing the
Old TTC warning after <N> days
entry.
•
TTC data is always stored and reloaded with project files. Please be
aware that after loading an older file containing valid TTC/12TC-data,
the currently active TTC/12TC is overwritten.
Remark: this behavior is essential for the correct recalculation of the results
of the stored data and is explicitly an intended behavior. An option to circum-
vent this, is to work with workshop files (see chapter 10 ).
•
The user is not allowed to change time-base settings when using a
particular TTC/12TC. A TTC/12TC is only valid for the time-base being
used during the TTC/12TC calibration measurements.
•
If an existing TTC/12TC is reloaded and the current device settings are
inconsistent to the time-base settings of the reloaded TTC/12TC, the
software automatically adjusts the device’s time-base settings.
•
By default, the current TTC/12TC is stored in the user application di-
rectory (the same directory where Seunis.config is located). If mul-
tiple users work with the same TTC/12TC under individual user ac-
counts, it is necessary to change the saving directory due to read/write
permissions of the file system. The saving directory can be changed
in the Options Dialog
→
Advanced tab (see 3.5.4 ).
42