10.
Programming (pairing) another ID transmitter into the main unit (max 8 ID
transmitters and smartphones)
Only a switched ON ID transmitter can be programmed into the main unit.
To enter into the programming mode, switch the ignition ON (so that the dashboard lights up) and disarm the
immobilizer (using the ID transmitter, PIN code or smartphone), then press the gas (acceleration) pedal 10
times. Two blinks of the indicator light on the dashboard will indicate entering into the programming mode.
Immediately press the ID transmitter button once. If the ID transmitter was programmed successfully into
the main unit, the dashboard indicator light will blink once.
The programming mode may be activated only for 60 seconds from switching the ignition ON. After
entering into the programming mode, DO NOT press any keys on the steering wheel, the radio, the
acceleration pedal or the brake pedal.
The ID transmitters should be programmed one-by-one – it is not possible to program more than one ID
transmitter at a time.
11.
Setting the PIN code (setting the buttons combination)
The PIN code
is a combination of any buttons available in a particular vehicle (supported buttons are listed
on the connection diagram for the respective vehicle). The PIN code is an alternative to the ID transmitter. If
a PIN code is set and you do not have your ID transmitter with you, the immobilizer may be disarmed by
entering the previously set combination.
To set or modify the PIN code
, you must switch the paired ID transmitter ON, start the vehicle ignition (but
do not start the engine), press the gas pedal (acceleration pedal) 10 times. Two blinks of the indicator on the
dashboard will indicate entering into the programming mode. Press the combination of 1 to 15 supported
buttons. Just after entering the combination, turn the car ignition off. If the PIN code was programmed
successfully into the main unit, the dashboard indicator light will blink once.
To check
if the code has been set correctly, turn off all the ID transmitters that are within range of the main
unit, turn the car ignition ON and enter the PIN code you just set. If the dashboard indicator will blink once
(indicating that the immobilizer was disarmed), the code has been set correctly. If not, repeat the PIN code
programming procedure. It’s necessary for the ignition to be switched ON when disarming using the PIN
code.
The installer can reset the existing PIN code.
NOTICE: According to UNECE Regulations 97 and the Directive 95/54 EEC, the code for disarming the
immobilizer must be one of at least 10,000 possible combinations. For SEO CANblu, the transmission
between the ID transmitter and the main unit is randomly coded with one of 2
128
possible combinations (2
128
= 340 undecillion = 340*10
36
). The set PIN code cannot limit the possible number of combinations to fewer
than 10,000. The installer offers all the know-how about this matter, which is available in the Installer’s
Manual.
v 1.0 150219
